Hobart MG1532 Meat Grinder / Mixer – 208 Volt 3 Phase
$5,500.00
Tested by our technicians and works great!
208 Volt, 3 Phase, 30 Amp
Will need hardwired into power by an electrician
150 lb hopper capacity, 55-60 lb per minute output
7.5 HP Grind Motor & 1 HP Mix Motor
Working pneumatic foot control
1 in stock
Approximately 48-3/4″ Tall x 26-7/8″ Wide x 50-3/4″ Deep
From the manufacturer:
GENERAL: The MG1532 has a 7.5 H.P. grind motor and 1H.P. mix motor. Casters and air-drive foot switch are standard.
ELECTRICAL CONTROLS: Electrical controls consist of front mounted water resistant switches, magnetic contactors, dual motor overload protection and foot switch operation capability. An electrical interlock switch is provided. Whenever the hopper lid is opened, power to the motors is shut off. The hopper lid must be in its proper operating position before the motors can be started.
CAPACITY: The MG1532 Mixer-Grinder hopper has meat capacity up to 150 pounds depending on the type of product. The grinding rate is 55 to 60 pounds of fresh boneless beef per minute, first or second cutting through a 1⁄8″ plate; 60 to 65 pounds of pork per minute second cutting through a 3⁄16″ plate. The MG1532 is for fresh or frozen meat tempered to 26 deg. F. or higher and can be in flake or stick form.
GRINDING END: The mixer-grinder is equipped with a “Wedge cylinder” grinding end. This grinding end is sized for #32 knives and plates (not included but optionally available).
FEEDING SYSTEM: The MG1532 is powered by two separate drive systems. A 1 H.P. motor drives the heavy-duty steel mixing arm. The arm rotates at 23 rpm and can easily be removed from the hopper for cleaning. The conveyor screw extends the full length of the hopper and cylinder. The screw rotates at a speed of 216 rpm. By depressing the MIX/GRIND START button both the mixing arm and the screw are operated. Both mixing and grinding are stopped when the STOP switch is depressed.
CLEANING: The mixing arm, conveyor screw, cylinder, and conveyor screw drive-shaft seal and mix arm seal are removable from the mixer-grinder for cleaning.
FINISH: The mixer-grinder consists of glass bead finished stainless steel hopper, stainless steel panels to enclose the base assembly and motors. The end ring and cylinder are stainless steel. The mixing arm and conveyor screw are tinned. The casters are stainless steel and nickel-chrome plated.
