Delfield 18660PTB 60″ Refrigerated Pizza Prep Table


1 in stock

From the manufacturer:

14 pan capacity
14.31 cu. ft. storage
1 Door is 19″ Wide and 1 door is 27″ Wide

Exterior top is constructed of one-piece 18-gauge stainless steel, with integral 2.12″ (5.4cm) high square nosing at the front. Top has a mechanically cooled refrigerated raised rail at the rear with openings to accommodate 2000 series pans (provided by others). Pans rest on a recessed stainless steel bracket. Rail interior is 22-gauge stainless steel. Raised rail openings have 20-gauge stainless steel removable lids. Unit is equipped with separate expansion valve and on/off switch for refrigerated rail. Temperature in top openings maintains 33°F (1°C) to 41°F (5°C) with pans recessed 2” (5.1cm) at 86°F ambient room temperature, meeting NSF 7 requirements.
Exterior back and bottom are 24-gauge galvanized steel. Exterior ends are finished with stainless steel.
Base interior has aluminum back and bottom. Base interior ends and door frames are thermoformed ABS plastic. Each interior door section has (1) 25” (63.5cm) deep removable epoxy coated wire shelf adjustable to (2) positions. Base is insulated with 2” (5.1cm) high density foamed in place polyurethane. End of base has a machine compartment with condensing unit installed. Rear machine compartment covered by a louvered panel.
Self Closing Door(s) have 22-gauge stainless steel exterior front, with a thermoformed ABS plastic interior liner.
Drawers — (2) high are standard.
Refrigeration system uses HFC-404A refrigerant. Cabinet has a blower coil assembly with expansion valve, located behind door mullion. Base is equipped with independently controlled thermostat, solenoid valve and condensate evaporator. Refrigerated base maintains temperature of 36°F (2°C) to 40°F (4°C). Recessed on/off switches for rail and base are located in front above the louver.
Electrical connections are 115 volts, 60 Hertz, single phase. Unit is wired with 3-wire, grounded, maximum 8’ (2.4m) cord and plug.
Casters: Equipment is mounted on 5” (12.7cm) diameter casters; overall height of casters is 6.13” (15.6cm).